The measurement results of the light distribution of the halogen headlamp of a Ford Kuga produced in 2017 serve as the example. In this case, too, prior to carrying out the test, the correct location for beamsetting is to be selected and all requirements met.
Light patterns / light distribution with acceptable adjustment.
- Low beam + high beam
- Beamsetter analog + digital
Fig.1
Fig.1: Vehicle front view
Light patterns - light distribution
Beamsetter / analog
Fig.2: - Low beam; H7;
Fig.3: - High beam; H15;
Fig.2; Low beam; left
Fig.3 High beam; left
Light patterns - light distribution
Beamsetter / analog
Fig.4: - Low beam; H7;
Fig.5: - High beam; H15;
Fig.4; Low beam; right
Fig.5; High beam; right
Ford Kuga = Halogen - version
Beam setting: mechanical
H7/H15
Hella article no.
8GH 007 157-xxx
8GJ 168 119-001
The vehicle must stand on a level test surface and comply with country-specific regulations.
Observe vehicle manufacturer’s instructions.
Headlamp adjustment location
Light patterns - light distribution
Beamsetter /
digital/ camera-based
Fig.6: - Low beam; H7;
Fig.7: - High beam; H15;
Fig.6; Low beam; left
Fig.;7; High beam; left
Light patterns - light distribution
Beamsetter /
digital/ camera-based
Fig.8: - Low beam; H7;
Fig.9: - High beam; H15;
Fig.8; Low beam; right
Fig.9; High beam; right
Important:
- Ensure correct battery voltage, connect charger if necessary (Fig.10).
Fig.11
Inclination 1%
Fig.10
Fig.11
Important:
- Perform visual inspection and technical check of headlamp.
Recommendation:
- Replace faulty light sources in pairs
Beamsetter IV -- analog --
Beamsetter V – digital --
Important safety note
Not helpful at all
Very helpful