Peugeot 206 - Engine malfunction indicator light is on | HELLA

Peugeot

206 1.6 HDI

Model year from 2005–2007

Engine code DV6TED4 (9HZ)

Engine malfunction indicator light is on

If a customer complains about the above error, this could be caused by a defective plug contact on the air flow sensor. The customer may also complain that the engine goes into limp home mode and that it has no power. Furthermore, various error codes can be displayed in connection with the air flow sensor. In this case, the wiring harness with plug must be installed using a repair kit with OE article number 6569Q9.

bi_d_electronics_peugeot_206_hdi_aufleuchten_der_motorkontrolleuchte001

bi_d_electronics_peugeot_206_hdi_aufleuchten_der_motorkontrolleuchte002

Caution!

The wiring harness in the repair kit has different coloured cables than the cable set installed at the factory. Make sure that you connect the cables correctly during assembly.

The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.

The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.

Further technical information

Maintenance Hints and Tips - Overrunning alternator pulley

Reading time: 1 minute

Suzuki Swift - ESP makes noises when car starts off

On the Suzuki Swift (A2L), noise may be generated by the ESP hydro unit when car starts off. What action should be taken and what could be the cause of this problem?

Reading time: 1 minute

Nissan Navara - Power loss - Error code P0093

The Nissan Navara may experience a loss in engine power, rough idling and an additional stored error code P0093

Reading time: 1 minute

Fiat 500 X - unable to remove ignition key

In the Fiat 500 X, faulty ESP/ABS control unit software may lead to various symptoms. What are the causes and what can you do?

Reading time: 1 minute

Opel Adam - engine cuts out after cold start

In the Opel Adam, faulty software in the engine control unit may lead to various symptoms. What are the causes and what can you do?

Reading time: 1 minute

Nissan X-Trail - Error code P1489

A software weakness in the engine control unit of the Nissan X-Trail causes the engine check lamp to light up and the error code P1489 is displayed.

Reading time: 1 minute

Toyota Aygo - Airbag control lamp lights up

With the Toyota Aygo it can happen that the airbag control lamp is permanently on and the error memory cannot be cleared.

Reading time: 1 minute

VW Transporter T6 - Rough idling/engine stalls

Does the VW T6's engine stall or run roughly when cold? There may be error codes stored in the control unit. Remedy?

Reading time: 1 minute

Hyundai Tucson - P0320 and the engine won’t start

In the Hyundai Tucson, it can happen that the engine starts sluggishly or not at all. There may also be ignition misfiring. The remedy for all this can be found here!

Reading time: 1 minute

Fiat 500 / 500C - engine control lamp lights up

On the Fiat 500, a software flaw in the engine control unit can cause the engine control lamp to come on while the car is being driven

Reading time: 1 minute

Not helpful at all

5

4

3

2

1

Very helpful