Mazda 2 - Low beam is not switched on automatically | HELLA
Mazda
Mazda 2
Model year: up until 07/2011
All models with automatic running lights
Low beam is not switched on automatically
If, in the case of the above-mentioned vehicle models with automatic running lights, the headlights are not set on "AUTO" in the headlight control switch, a possible cause of failure may be a defective ambient light sensor.
This sensor is integrated in the rain sensor module.
Remedy:
When troubleshooting, first check the manual switch functions, the wiring and then the power supply for defects.
If no further faults are found, the ambient light sensor should be checked and replaced if necessary.
Please follow the repair instructions specified by the vehicle manufacturer for the carrying out of such work.
Further technical information
Repair Tips
Mercedes - fault codes U118A02, B178392, U120B97
In the Mercedes 167/177/213/238/257, a software error in the headlamp control unit may lead to various symptoms. What can be done?
Reading time: 1 minute
Repair Tips
VW Polo V - replacement of light source for halogen headlamps
For the VW Polo V (6R/6C), the bulbs of the halogen headlamp can be replaced as described in our article.
Reading time: 1 minute
Repair Tips
Audi TT Condensation in the headlamp
Reading time: 1 minute
Repair Tips
Opel Adam Stop lamps permanently on
Reading time: 1 minute
Repair Tips
Fiat Idea Lancia Musa Hazard warning signal switches on without being activated
Reading time: 1 minute
Repair Tips
Lancia Ypsilon 843 Malfunction "Third stop light"
Reading time: 1 minute
Repair Tips
Mercedes Benz A Class Rear combination lamp with reduced luminosity
Reading time: 1 minute
Repair Tips
Audi Q5 Reversing light sporadically not functioning
Reading time: 1 minute
Repair Tips
Volkswagen Eos Interior lighting activates while driving
Reading time: 1 minute
Repair Tips
Mercedes Benz B Class Vehicle lighting malfunction
Reading time: 1 minute