If the above-mentioned error is identified, one possible cause may be a faulty signal evaluation in the engine control unit.
In order to exclude any other sources of interference, first of all a check should be carried out on the periphery (power supply, engine oil level, sensor, etc.)
If then no errors are found and all the measured values correspond to the specifications, a software update of the engine control unit is required.
The update can be carried out, for example, via macsRemote Services or with a pass-thru-capable diagnostic device of the Mega Macs series and
registered access to the vehicle manufacturer's online portal.
If no appropriate equipment is available, please contact an authorised workshop.
Important safety note
Not helpful at all
Very helpful