In this repair case, the customer criticises an unpleasant, squeaky noise in the area of the C-pillar when driving.
Troubleshooting:
When checking the door lock mechanism, it emerges that the lower fixing screw (figure 1) of the door locking plate has been made too long. This results in contact between the screw tip and the inner sheet metal of the right C-pillar (can also affect the left C-pillar).
Remedy:
- Disassemble the fixing screw (figure 1)
- Shorten the screw by approx. 1.5 mm at the screw tip (figure 2)
- Install the fixing screw and tighten to the torque specified by the vehicle manufacturer
- Repeat this measure on the left side if necessary (locking plate of the left C-pillar)
Finally, a test drive should be performed to check the repair work.
Please note that such work should only be carried out by an authorised specialist garage and that the vehicle manufacturer's repair and maintenance instructions must be observed!
Figure 1
Figure 2
Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.
The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.
Not helpful at all
Very helpful