If the above-mentioned error is identified, one possible cause may be a faulty signal evaluation in the engine control unit.
In order to exclude any other sources of interference, first of all a check should be carried out on the periphery (power supply, engine oil level, sensor, etc.)
If then no errors are found and all the measured values correspond to the specifications, a software update of the engine control unit is required.
The update can be carried out, for example, via macsRemote Services or with a pass-thru-capable diagnostic device of the Mega Macs series and
registered access to the vehicle manufacturer's online portal.
If no appropriate equipment is available, please contact an authorised workshop.
Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.
The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.
Not helpful at all
Very helpful