Vehicle occasionally stalls; impaired idle speed control
If the above-mentioned symptoms occur on these vehicles, this may be caused by a dirty throttle valve. In this case, check the blow-by hole and, if necessary, drill open to 2mm. Afterwards, the ECU must be reprogrammed with a software modified for this purpose. The ECU software can only be updated by an authorised dealer.
Note: If a white dot (1) is already on the throttle body, this measure has already been done.
If not, proceed as follows:
· Remove the throttle body
· Secure the throttle body in a vice, protecting the contact faces from damage with a cloth rag.
· Drill blow-by connector (2) open and clean.
Make sure that no chips remain in the throttle body.
· Install the throttle body
· Mark throttle body with white dot at position (1)
· Program engine control unit
· Teach throttle adaptation using diagnostic tool. Be sure to follow the instructions from the car manufacturer.
Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.
The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.
Not helpful at all
Very helpful