There have been complaints that the battery charger door (figure 1) of the vehicles specified above cannot be opened.
The malfunction indicator lamp may light up and the error code DTC P0CD2 (battery charger door not open) may be set in the electronic control unit.
The cause for the issue mentioned above may be the rubber seal (figure 2) of the battery charger door.
The rubber seal (figure 2) may jam in the opening (figure 3) or freeze at low temperatures.
Proceed as follows to rectify the problem:
· Carefully open the door with a plastic wedge (figure 4).
· Apply special oil (vehicle manufacturer article number 93165293) to the outside and inside (as indicated, figure 5) of the rubber seal.
· Remove the error using a diagnostic unit (e.g. mega macs 56 Hella- Gutmann).
Repeat the process as described if necessary.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.
The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.
Not helpful at all
Very helpful