Mercedes E-Class W211 - noise when starting off & changing from forward to reverse
| Data sheet | |
|---|---|
| Manufacturer | Mercedes |
| Vehicle model | E-Class W211 |
| Engine | All |
| Year of manufacture | 2002 - 2010 |
| Symptoms | Noise when starting up |
Important safety note
Noise from the rear of the vehicle when starting up
On the vehicles mentioned above, non-specific, knocking or clicking noises may occur from the vehicle rear area. These are particularly noticeable when starting off or when changing from forward to reverse.
- Remove the drive shaft joint of the rear wheel hub (if necessary, remove the drive shaft)
- Clean the contact surfaces of the drive shaft joint and wheel bearing (wheel hub)
- Apply special lacquer (A0009890152) to the contact surface of the drive shaft and allow to dry for at least 1 hour
- Mount the drive shaft, using a new fastening nut and observing the torque specification
- Carry out a test drive
Carrying out the measure on both sides of the vehicle is recommended.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval; indication of the document source is also required. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful