If there are complaints about the above mentioned fault, the problem may be caused by a faulty or incorrect brake lamp switch (brake pedal position switch). The error rate C1200 may also be saved in the ESP control unit at the same time.
Remove brake lamp switch and visually inspect for correct part no.
Note:
The part no. 001 545 2109 is not the correct brake lamp switch in this case.
Remove brake lamp switch, visually inspect for correct part no. and fit the new, correct brake pedal position switch.
Brake lamp switch (service part no.:) 001 545 3109
Then clear the exiting entries in the error memory.
Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.
The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.
Not helpful at all
Very helpful