If a customer complains about the above problem, this could be caused by the servo motor for the swirl flaps (see Fig. 1). Oil may reach the servo motor through the air hose. Under certain circumstances this can cause a short circuit inside the servo motor. This causes the engine to go into emergency mode, resulting in fault code entries for the servomotor. In addition, the fuses for the motor control unit (F43, F44, Fig. 2) may blow. They are located in the fuse box in the engine compartment. The fuse box is located on the front left, near the splash wall. In this case, the servo motor must be replaced. Furthermore, the oil deposits in the turbocharger hose should be removed and the fuses should be replaced if necessary. Clear the fault codes after the repair.
Fig. 1
Fig. 2
Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.
The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.
Not helpful at all
Very helpful