Lancia Ypsilon 843 - Malfunction "Third stop light" | HELLA
Lancia
Ypsilon 843
Model years: 2003 – 2011
Malfunction "Third stop light"
If the Lancia Ypsilon (Fig.1) is found to have a fault or partial failure (Fig.2) affecting the "third" stop light, the possible cause may be individual defective light sources.
Fig.1
Repair notes
We recommend the following procedure:
- Completely switch off the electrical system.
- Remove the faulty stop light. To do so, remove the covers (Fig.3) and unlock the clips (Fig.4).
- Then remove the light unit (Fig.5) and unplug the connector.
Fig.2
Fig.3
Fig.4
Fig.5
- Disconnect the bulb holder from the housing
- Remove the faulty bulbs and replace
- Re-assemble the third stop light in reverse order and install.
Then carry out a function test.
Spare parts required: 8GP 938 026-001 (W 2.3 W)
Note
To ensure a constant light pattern, we recommend replacing all bulbs in this situation.
Fig.6
Fig.8
Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.
The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.
Not helpful at all
Very helpful