If a customer complains about the above error, this could be caused by a defective plug connection. The following fault codes, among others, may be stored: B 1353 and B 2500. Due to a fault on the male connector housing of the wiring harness, this is not engaging correctly in the airbag control unit. In this case, the connector must be checked and replaced if necessary. The airbag control unit is located below the centre armrest.
When installing the new male connector housing, make sure it locks correctly. Delete the stored error codes.
Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.
The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.
Not helpful at all
Very helpful