Citroen Berlingo - Failure of the low beam | HELLA
Citroen
Berlingo
Model years 2002-2008
Failure of the low beam
If a customer complains about the above problem, this could be caused by a frayed cable harness. Additionally there may be electrical failures/malfunctions. The cable harness runs from the fuse box in the engine compartment (front left) through a passage opening in the wheel arch to the headlamps. Since the cable is not protected at this opening, it may become frayed here due to vibration. This then leads to the above-mentioned problems. In this case, the damaged areas on the cable must be repaired. Then protect the cable harness in the area of the passage hole with a corrugated pipe in order to avoid repeated chafing. Below is a summary of corrugated pipes. For details on installation material, refer to Hella Bulletin with order 9Z2 999 029-115.
Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.
The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.
Not helpful at all
Very helpful