If the customer complains about the above problem, this could be caused by the controller for the ABS/anti-skid system (ASC) and the electronic stability program (DSC). The failure of power steering may occur immediately after engine start. But It is not uncommon that the system is working perfectly after restarting the engine. However, the problem typically reappears after a short time. In addition, the fault code 130 may be stored (No signal from speedometer). In this case, an upgraded controller must be installed.
Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.
The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.
Not helpful at all
Very helpful