Seat Arona - noise from the front of the vehicle when manoeuvring
| Data sheet | |
|---|---|
| Manufacturer | Seat |
| Vehicle model | Arona |
| Engine | All models |
| Year of manufacture | 2017 - 2021 |
| Symptoms | Noises in the front area when manoeuvring |
Important safety note
Noises in the front area when manoeuvring
The following problem is observed on the vehicles mentioned above.
The noise may occur when manoeuvring the vehicle.
The cause was diagnosed as unwanted friction between the front suspension strut and the shock absorber bump stop.
Please proceed as follows to rectify the problem.
- To access the shock absorber piston rod, lift the protective cover and bump stop upwards.
- Thoroughly clean all contact surfaces and coat them with
silicone grease article no. G 000 405 A2
- Assemble the dismantled parts in reverse order.
- Repeat the procedure on the other side of the vehicle.
Finally a test drive should be performed to check the repair work.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval; indication of the document source is also required. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful