If one or more of the above-mentioned errors occurs in these vehicle models, one potential cause for this may that water has entered the plug sockets of the wheel rotational speed sensors on the rear axle. In this case, the plug sockets of the cable sets for the ABS sensors must be checked at the wheel hubs. If water has entered at the plug sockets or corrosion is already noticed, the affected plug and sensor must be replaced. Unaffected or new plug sockets should be greased with silicone grease prior to installation.
Important safety note
Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval and indication of the source. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful