Lancia Ypsilon 843 - Malfunction "Third stop light" | HELLA
Lancia
Ypsilon 843
Model years: 2003 – 2011
Malfunction "Third stop light"
If the Lancia Ypsilon (Fig.1) is found to have a fault or partial failure (Fig.2) affecting the "third" stop light, the possible cause may be individual defective light sources.
Fig.1
Repair notes
We recommend the following procedure:
- Completely switch off the electrical system.
- Remove the faulty stop light. To do so, remove the covers (Fig.3) and unlock the clips (Fig.4).
- Then remove the light unit (Fig.5) and unplug the connector.
Fig.2
Fig.3
Fig.4
Fig.5
- Disconnect the bulb holder from the housing
- Remove the faulty bulbs and replace
- Re-assemble the third stop light in reverse order and install.
Then carry out a function test.
Spare parts required: 8GP 938 026-001 (W 2.3 W)
Note
To ensure a constant light pattern, we recommend replacing all bulbs in this situation.
Fig.6
Fig.8
Important safety note
Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval and indication of the source. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful