If the customer complains about the above problem, this could be caused by the controller for the ABS/anti-skid system (ASC) and the electronic stability program (DSC). The failure of power steering may occur immediately after engine start. But It is not uncommon that the system is working perfectly after restarting the engine. However, the problem typically reappears after a short time. In addition, the fault code 130 may be stored (No signal from speedometer). In this case, an upgraded controller must be installed.
Important safety note
Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval and indication of the source. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful