BMW 2 Series Active Tourer - changing the cabin air filter
| Data sheet | |
|---|---|
| Manufacturer | BMW |
| Vehicle model | 2 Series Active Tourer (F45) |
| Engine | All |
| Year of manufacture | 2014 - 2021 |
| Symptoms | Replacing the cabin filter |
Important safety note
Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their work. The information provided on this website is intended for use by suitably qualified personnel only.
Pollen filter replacement for the BMW 2 Series Active Tourer
When replacing the cabin air filter on the above-mentioned vehicle, some points should be observed and therefore you should proceed as follows:
- Figure 1: Remove the trim in the footwell on the passenger side by first of all removing the screws (2x).
- Figure 2: Remove the left cover in the footwell on the passenger side, again by first removing the two screws
- Figure 3: Remove the air outlet by removing the screw (1x) and pulling the air outlet to the right
- Figure 4: Pull off the hose from the heating/air-conditioning housing to the right
- Figure 5: Unlock and remove the cover from the heating/air-conditioning housing
- Figure 6: Pull out the cabin filter
In order to install the new filter, proceed as above but in reverse order.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval; indication of the document source is also required. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful