If the problem described above is determined, the cause could be an insufficiently secured steering column.
In this case, there is the possibility that the screw (see image) was not tightened to the specified tightening torque when the steering column was fitted.
This can lead to inconsistencies in the steering behavior.
Remedy:
Have the vehicle checked immediately in an authorized specialist garage.
The tightening torque of the screw is checked and it is tightened to the correct tightening torque specified by the manufacturer (20Nm + 180°), if required.
The action is documented with a sticker and the lettering "45N7" in the area of the spare wheel well.
The vehicle manufacturer has already addressed the issue and notified owners of all models affected. For various reasons, however, it must be assumed that not all vehicles have been checked or modified.
Important safety note
Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval and indication of the source. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful