In this repair case, the customer criticises an unpleasant, squeaky noise in the area of the C-pillar when driving.
Troubleshooting:
When checking the door lock mechanism, it emerges that the lower fixing screw (figure 1) of the door locking plate has been made too long. This results in contact between the screw tip and the inner sheet metal of the right C-pillar (can also affect the left C-pillar).
Remedy:
- Disassemble the fixing screw (figure 1)
- Shorten the screw by approx. 1.5 mm at the screw tip (figure 2)
- Install the fixing screw and tighten to the torque specified by the vehicle manufacturer
- Repeat this measure on the left side if necessary (locking plate of the left C-pillar)
Finally, a test drive should be performed to check the repair work.
Please note that such work should only be carried out by an authorised specialist garage and that the vehicle manufacturer's repair and maintenance instructions must be observed!
Figure 1
Figure 2
Important safety note
Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval and indication of the source. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful