The overrunning alternator pulley, also known as the alternator freewheel clutch, must be checked regularly to ensure that the unit drive is functioning correctly and to prevent damage.
An alternator freewheel clutch can be tested as follows:
1.
A defective freewheel can be identified by the unit drive not running truly and the ensuing noise. An alternator with an intact freewheel should slow down and come to a standstill when the engine is switched off.
2.
If the freewheel is working correctly, the shaft will rotate freely in one direction and is locked in the other direction. Depending on the manufacturer, there may be increasing resistance in the locked direction.
The alternator freewheel clutch must be replaced if the above results are not achieved.
The overrunning alternator pulley must always be tested whenever any repair work is performed on the unit drive.
We recommend the following procedure:
Please observe the relevant vehicle manufacturer's repair and maintenance instructions in this regard.
Important safety note
Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval and indication of the source. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful