Engine will not start
If a customer complains about the above error, this could be caused by a defective plug connection. Due to poor contacting, the display indicates drive position "A1" in the cockpit, although the selector lever is in neutral position. As a result, the engine will not start. In addition, error codes for the manual gearbox may be stored. In this case, flawless contact between the drive position switch and the multi-contact plug must be tested; see figure1 and 2. If the plug socket has been disengaged, secure fit must be permanently established.
Important safety note
Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval and indication of the source. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful