Dacia Sandero - ignition switch stuck and starter pinion does not disengage
| Data sheet | |
|---|---|
| Manufacturer | Dacia |
| Vehicle model | Sandero |
| Engine | All models |
| Year of manufacture | 2013 - 2021 |
| VIN | UU15SDKJ558926581 - UU1HSDM9G60030836 |
| Symptoms | Ignition switch stuck, starter pinion does not disengage |
Important safety note
Ignition switch stuck, damage to starter possible
The following problem is observed on the vehicles mentioned above.
When starting the vehicle, the ignition switch gets stuck in the start position.
A defective ignition switch was diagnosed as the cause.
Please proceed as follows to rectify the problem: Replace the defective ignition switch with a new one according to the manufacturer's specifications. Check the starter motor and peripherals (wiring harness etc.) for damage and replace or repair if necessary.
Finally a test drive should be performed to check the repair work.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval; indication of the document source is also required. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful