If a customer complains about the above problem, this could be caused by the crankshaft sensor. Defective pins of the two-pin connector may cause the problems listed below. Additional complaints may be poor throttle response and stalling of the engine. The following fault codes may be stored:
- P 0335 – crankshaft position sensor, A circuit functional error.
- P 0336 – crankshaft position sensor, A circuit range and functional error.
- P0606 - powertrain controller, processor error
If this is the case, the crankshaft sensor must be checked. The sensor signal can usually be displayed by a diagnostic tester via the "Measurements/Parameters" menu. The signal can also be visualised using an oscilloscope, see Figure 1. The Figure shows a good signal.
Fig. 1
Important safety note
Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only.
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval and indication of the source. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful