High-beam assist

Depending on the manufacturer, vehicles equipped with a high-beam assistant must be dealt with separately. With several manufacturers, the glare-free high beam is adjusted together with the low beam. The system is only checked in the event of complaints by customers. With other manufacturers, checking/adjustment is mandatory. Before carrying out the high beam assist adjustment, the vehicle should be prepared in accordance with the statutory regulations (correct tire pressure and loading, etc.) and the manufacturer's instructions. To perform the subsequent adjustment of the vertical cut-off line, the headlamp modules must be in the basic setting. This can be achieved using a diagnostic tester. A special aiming screen in an analog beamsetter is required for several high beam assistance systems. The SEG IV series by Hella Gutmann Solutions is equipped with this kind of aiming screen.

During this procedure, the headlamp modules are moved into a specific position and the vertical cut-off line is activated, as in the graphic which shows the headlamp on the left as an example.

The vertical line of the light distribution (orange arrow) must now be precisely adjusted with reference to the center line, or the zero line of the aiming screen. The new setting is then stored as the normal position. In the case of the vertical cut-off line, correct adjustment is absolutely essential as otherwise other road users may be exposed to extreme glare. The adjustment of the headlamp on the right is to be performed mirror-inverted.

Headlamps also exist in which adjusting screws for adjustment of the high beam distribution are no longer available. This is the case with the new Audi A8 with Matrix Beam headlamps, for example.

The heart of the Matrix LED headlamp is a glare-free high beam which has been implemented using a non-mechanical system. This allows the driver to travel in their vehicle with a permanent high beam without risk of dazzling oncoming traffic or any vehicles in front. A camera detects oncoming traffic and traffic in front, and individual LEDs are then switched off or dimmed within fractions of a second to exclude these vehicles from the field of high beam light distribution. The use of Matrix technology allows, for the first time, several "tunnels" to open simultaneously. One example of this is the scenario where several oncoming vehicles are driving one behind the other. While these are "shielded", the high beam continues to illuminate all the areas between the vehicles and to the left and right of them at full power. As soon as no vehicle is in the driver’s field of vision any longer, the system reverts to full high beam lighting. In addition to specifically shielding other vehicles, the light cone of the Matrix high beam also adapts to the driving situation, for instance in the case of negotiating bends when the cornering light function is required. In such a situation, the intensity of the light cone can be varied at the side or focused on the middle of the road by controlling the LEDs in different ways. Consequently the driver’s visibility at night improves dramatically while, at the same time, the risk of subjecting oncoming traffic to glare is eliminated.

This light-specific phenomenon is a frequently recurring theme which is dealt with in various reports. But what exactly causes it? The "blue edge" refers to the light component in the area of the cut-off line which frequently has a bluish white light colour.

The characteristic and intensity of the edge depends on several factors. Here are some examples:

1. Lens material of projection module
The light refraction or diffusion varies depending on the material of the focusing lens, which can be glass, polymethylmethacrylate, or polycarbonate, for example. This affects the light colour.

2. Position of the light source in relation to the bulb shield
Light sources are mounted at different distances and positions (vertically) in relation to the bulb shield. Light is therefore "refracted" or "diffracted" differently at the bulb shield.

3. Reflector or projector-type system
The way in which light is emitted or focused also has an effect on the cut-off line. The blue edge of a reflector-type system is normally not as pronounced as that of a projector-type system. The reason for this is the so-called "degree of hardness". This refers to the light-to-dark transition (cut-off line). Projector-type systems have a higher degree of hardness due to the bulb shield.